Omnia One Multicast/Dab & Studio Pro - Omnia Stereo Audio Processor Installation And Operation Manual

Omnia ONE Multicast/DAB & Studio Pro
Note: All measurements made using "Bypass" mode, which is available in the Input/Output
menu.
General Audio Specifications
Frequency Response: ± 0.50 dB, 20 Hz to 20 kHz with high pass filter disabled.
Distortion:
*Signal-Noise Ratio: Greater than -100 dB, 20 Hz –- 20 kHz bandwidth, referenced to 0dBfs
*The measured noise floor will depend upon the settings of the Input and Output Gain controls and is primarily governed
by dynamic range of the Crystal Semiconductor A/D Converter which is specified as >100 dB. The dynamic range of the
internal digital signal processing chain is >144 dB.
Stereo Separation: Greater than 80 dB, 20 Hz –- 20 kHz; 90 dB typical.
Analog Audio Input: Left/Right Stereo.
A/D Conversion:
Connectors:
Analog Audio Output: Left/Right Stereo. Electronically balanced.
D/A Conversion:
Connectors:
Digital Audio Input: Configuration: Two-channel stereo per AES3 standard via CS8420 Digital
As of February 2009 – Version 2.2 Multicast, DAB or Studio Pro Software
Less than 0.05% THD 20 Hz – 20 kHz bandwidth.
Electronically balanced.
Input impedance 10k ohms resistive.
Maximum Input Level +24 dBu.
Nominal Input Level: +4dBu (A +12dBu input results in –12dBFS input
meter reading with Input Gain set to 0.0dB. A 0dBu input signal results in
a -12dBFS input level when Input Gain is +12dB.)
Crystal Semiconductor 24 bit 128x oversampled delta sigma converter
with linear-phase anti-aliasing filter. Pre-ADC anti-alias filter, with high-
pass filter at <10 Hz.
Two, EMI-suppressed XLR-female. Pin 1 chassis ground, Pin 2 "Hot".
Output Impedance 20 ohms.
Minimum load Impedance 600 ohms.
Output Level adjustable from -2 dBu to +22dBu peak in 0.1dB steps.
Crystal Semiconductor CS4390 24 bit, 128x oversampled.
Two, EMI-suppressed XLR-male. Pin 1 chassis ground, Pin 2 "Hot".
Audio Transceiver with 24-bit resolution. Software selection of stereo,
mono from left, mono from right or mono from sum. Automatically
accepts sample rates between 24 kHz and 96 kHz.
90