Table of Contents
Advertisement
5-2
5.2 Upgrading on-board flash memory from
Ethernet network
You can update the on-board flash memory after you booting the new
firmware from the Ethernet network by issue the following commands.
↵
> home
> flashfs rewrite boot.bin
(
this command is available for update boot code only)
> flashfs update
↵
> flashfs ls
You should see some messages about the file name and file sizes that
stored in the Router. If you get "
wrong.
Managing the xDSL Router
↵
↵
no flash content
" something went
Advertisement
Table of Contents
