Cisco TelePresence Administrator's Manual page 231

Grey Headline (continued)
Command reference - xConfiguration
Zones LocalZone SubZones MembershipRules Rule [1..3000] Type: <Subnet/AliasPatternMatch>
The type of address that applies to this rule.
Subnet: assigns the device if its IP address falls within the configured IP address subnet.
AliasPatternMatch: assigns the device if its alias matches the configured pattern.
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 Type: Subnet
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter Limit: 1920
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter Mode: Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if the mode is set to Limited).
Default: 1920
Example: Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Limit: 1920
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
NoBandwidth: no bandwidth available. No calls can be made within this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Mode: Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if the mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth Total Limit: 500000
Zones LocalZone SubZones SubZone [1..1000] Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth Total Mode: Limited
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
231
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices