Table of Contents
Advertisement
WINE AND BEVERAGE CABINET USE AND CARE MANUAL
I N S T A L L I N G T R U E S I G N A T U R E
L O U V E R G R I L L F O R S T A C K E D U N I T S
Tools Required:
• 3/8" socket and ratchet
• #2 Phillips screw driver
• Level
• Floor protector
True Signature Louver Grill Kit
1) Lay floor protectant down.
2) Uncrate cabinets and secure both shelving and doors/drawers.
3) Install the anti-tip device per its instructions. (See page 5).
4) Trial fit anti-tip brackets using the lower cabinet.
5) Carefully lift the top cabinet and place on the lower cabinet.
This procedure requires assistance. Level the top cabinet.
6) Position the upper refrigerator so that it is flush with the lower
cabinet's sides and back.
7) Install the rear stacking brackets. (See image 1).
8) Place set in final spot. Level both top and bottom unit. Use a
level on the inside of the cabinets. Check front to back and side
to side. (See image 2).
9) Remove front grill on both cabinets by removing the two
screws securing the grill. Then tilt the grill towards you and push
down. (See image 3).
(Continued on next page.)
14
WARNINg
StACkIng More thAn 2 unItS hIgh WIll CAuSe dAMAge to
the unItS And IS not reCoMMended.
Stacking
Brackets
Image 1.
Image 2.
Image 3.
Hide quick links:
Advertisement
Table of Contents
