Table of Contents
Advertisement
WINE AND BEVERAGE CABINET USE AND CARE MANUAL
I N S T A L L I N G O V E R L AY PA N E L S F O R G L A S S
D O O R & S O L I D D O O R M O D E L S
Tools Needed:
• Phillips Screwdriver
• 3/8" Wrench
• 1/8" Drill Bit
See page 6 for custom panel
dimensions before installing.
For easy overlay installation, refrigerator door
removal is required.
1) Open the door and remove the two top Phillips screws from
the bottom louver grill. (See image 1). Set the two screws to the
side for later reinstallation.
2) Hinge the louver grill down and lay it onto the floor. (See
image 2). Be careful not to tug on the wires connected to the
temperature display.
3) To remove the door, back out two bottom hinge screws with a
3/8" wrench. (See image 3). Secure door while removing screws.
4) Remove two Phillips screws from the top hinge.
(See image 4). Save all these screws for later reinstallation.
5) Lay the door on a safe solid surface. If retrofitting a glass
door model, be cautious not to damage the glass. Lay cardboard
or other soft or safe material down before working on the door.
(See image 5).
6) Remove door gasket from the inside of the door frame. (See
image 5). Place gasket to the side for later reinstallation.
(Continued on next page.)
Image 1. Remove two Phillips screws from bottom louver grill.
10
Image 2. Removing bottom louver grill.
Image 3. Remove bottom door hinge screws.
Image 4. Remove top hinge screws.
Image 5. Remove door gasket.
Two 3/8" bottom
hinge screws
Hide quick links:
Advertisement
Table of Contents
