Table of Contents
Advertisement
7.1 High-Definition Professional Surround Processor
16 • 7.1 High-Definition Surround Processor: HD-XSP
NOTE: Observe the following guidelines when installing equipment in a rack:
•
Elevated Operating Ambient Temperature - If installed in a closed or
multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment
compatible with the maximum ambient temperature (Tma) specified by the
manufacturer.
•
Reduced Air Flow - Installation of the equipment in a rack should be such
that the amount of airflow required for safe operation of the equipment is
not compromised.
•
Mechanical Loading - Mounting of the equipment in the rack should be
such that a hazardous condition is not achieved due to uneven mechanical
loading.
•
Circuit Overloading - Consideration should be given to the connection of
the equipment to the supply circuit and the effect that overloading of the
circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used
when addressing this concern.
•
Reliable Earthing - Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (e.g., use of power strips)
NOTE: If rack mounting is not required, rubber feet are provided for tabletop
mounting or stacking. Apply the feet near the corner edges on the underside of the
unit.
To install the ears, use the following procedure.
CAUTION: To prevent equipment damage, use only the rack ears Crestron
provides for this device.
1.
There are screws that secure each side of the HD-XSP top cover. Using a #1
or #2 Phillips screwdriver, remove the three screws closest to the front
panel from one side of the unit. Refer to the diagram following step 3 for a
detailed view.
2.
Position a rack ear so that its mounting holes align with the holes vacated
by the screws in step 1.
3.
Secure the ear to the unit with three screws from step 1, as shown in the
following diagram.
Crestron HD-XSP
Operations & Installation Guide – DOC. 7446A
Advertisement
Table of Contents
