Table of Contents
Advertisement
Crestron HD-XSP
Default Router
Control System
Operations & Installation Guide – DOC. 7446A
7.1 High-Definition Professional Surround Processor
6.
To save the subnet mask and return to the "Network Setup" menu, move the
cursor to the rightmost octet and press SELECT. To cancel the operation
and return to the previous screen, press BACK.
If any changes were made, the HD-XSP reboots upon exiting the "Installer"
menu.
The default router can be manually set or obtained from a DHCP server. For
information on enabling DHCP to obtain a default router, refer to "Enable/Disable
DHCP" on page 29.
NOTE: If DHCP is enabled, any changes made do not take effect.
To manually set the default router:
1.
Open the "Network" menu as described in "Configure Network" on page
28.
Press ∧ or ∨ to highlight Default Router and press SELECT.
2.
If DHCP is enabled, the default router and a message stating "DHCP On:
Address Invalid" is displayed. Otherwise controls for setting the default
router are displayed in the "Default Router" screen.
"Default Router" Screen
Default Router
[0].0.0.0
3.
Press ∧ or ∨ to set the first octet of the default router.
4.
Press < or > to move the cursor between octets (or press SELECT to move
to the next octet) to select for editing.
5.
Repeat steps 3 and 4 for each octet.
6.
To save the default router and return to the "Network Setup" menu, move
the cursor to the rightmost octet and press SELECT. To cancel the
operation and return to the previous screen, press BACK.
If any changes were made, the HD-XSP reboots upon exiting the "Installer"
menu.
The "Control System" menu is used to specify the HD-XSP's IP ID and the IP
address of the control system. To specify the IP ID and the control system IP
address:
1.
Open the "Network" menu as described in "Configure Network" on page
28.
Press ∧ or ∨ to highlight Control System and press SELECT. The "Control
2.
System" menu is displayed.
7.1 High-Definition Surround Processor: HD-XSP • 31
Advertisement
Table of Contents
