Table of Contents
Advertisement
7.1 High-Definition Professional Surround Processor
Subnet Mask
30 • 7.1 High-Definition Surround Processor: HD-XSP
"IP Address" Screen
IP Address
[10].0.0.111
3.
Press ∧ or ∨ to set the first octet of the IP address.
4.
Press < or > to move the cursor between octets (or press SELECT to move
to the next octet) to select for editing.
5.
Repeat steps 3 and 4 for each octet.
6.
To save the IP address and return to the "Network Setup" menu, move the
cursor to the rightmost octet and press SELECT. To cancel the operation
and return to the previous screen, press BACK.
If any changes were made, the HD-XSP reboots upon exiting the "Installer"
menu.
The subnet mask can be manually set or obtained from a DHCP server. For
information on enabling DHCP to obtain a subnet mask, refer to "Enable/Disable
DHCP" on page 29.
NOTE: If DHCP is enabled, any changes made do not take effect.
To manually set the subnet mask:
1.
Open the "Network" menu as described in "Configure Network" on page
28.
Press ∧ or ∨ to highlight Subnet Mask and press SELECT.
2.
If DHCP is enabled, the subnet mask and a message stating "DHCP On:
Address Invalid" is displayed. Otherwise, controls for setting the subnet
mask are displayed in the "Subnet Mask" screen.
"Subnet Mask" Screen
Subnet Mask
[255].255.255.0
3.
Press ∧ or ∨ to set the first octet of the subnet mask.
4.
Press < or > to move the cursor between octets (or press SELECT to move
to the next octet) to select for editing.
5.
Repeat steps 3 and 4 for each octet.
Crestron HD-XSP
Operations & Installation Guide – DOC. 7446A
Advertisement
Table of Contents
