Assigning Transport Controls, And Overview - JLCooper Electronics MCS-3800 User's Reference Manual

Assigning Transport Controls
An Overview
The general procedure to change (edit) what a control sends or
change its name, is to enter Assign Mode by pressing Assign.
then do the following:
1. Select the control by moving it. This control is "held" in the
LCD display, and you cannot at this point decide to edit a
different control.
If you meant to edit a different control, press Assign twice to
exit and re-enter Assign mode.
2. Make the desired edit, by turning the rotary encoders below
the parameters shown the LCD.
3. Use the right-most encoder to change pages, to see and edit
more parameters for a single control.
4. To keep the changes, and store them to memory, press Enter
on the Keypad.
5. You may then proceed to select another control to edit.
6. To discard the changes, do not press Enter. Simply press
Assign to exit Assign mode.
7. When you are done editing, be sure that you have exited
Assign mode. Yellow LED off.
51