Sun Microsystems Sun Fire V210 Manual page 25

OBP Configuration Parameters Stored On The System Configuration Card
TABLE 1-6
Parameter
silent-mode?
scsi-initiator-id
oem-logo?
oem-banner?
ansi-terminal?
screen-#columns
screen-#rows
ttya-mode
ttyb-mode
output-device
input-device
load-base
auto-boot?
boot-command
diag-file
diag-device
boot-file
boot-device
use-nvramrc?
nvramrc
security-mode
security-password
Default Description
Suppress all messages if true and diag-
false
switch? is false
scsi-id of the scsi controller
7
If true, use custom OEM logo, otherwise,
false
use Sun logo
If true, use custom OEM banner
false
true
Sets number of columns on screen
80
Sets number of rows on screen
34
ttya (baud rate, #bits, parity, #stop,
9600,8,n,1,-
handshake)
ttyb (baud rate, #bits, parity, #stop,
9600,8,n,1,-
handshake)
Power-on output device
ttya
Power-on input device
ttya
Address
16384
If true, boot automatically after power on
true
or reset
Action following a boot command
boot
File from which to boot if diag-switch?
none
is true
Device to boot from if diag-switch? is
net
true
File to boot if diag-switch? is false
none
Device(s) from which to boot if diag-
disk net
switch? is false
If true, execute commands in NVRAMRC
false
during server start-up
Command script to execute if use-
none
nvramrc? is true
Firmware security level (options: none,
none
command, or full)
Firmware security password if security-
none
mode is not none (never displayed) - do not
set this directly
Chapter 1 Introduction 11