Advertisement
Authentication
Enables or disables checking the sender's phone number against the allowed sender white list for incoming diagnostics and
command execution SMS messages.
If authentication is enabled, the router will check if the sender's number exists in the white list. If it exists, the router then checks the
password (if configured) in the incoming message against the password in the white list for the corresponding sending number. If
they match, the diagnostic or command is executed.
If the number does not exist in the white list or the password does not match, the router does not execute the incoming diagnostic
or command in the SMS message.
This is enabled by default and it is strongly advised that you leave this feature enabled to maintain security.
Send Ack. SMS for Set Command
The M2M CDMA Router will automatically reply to certain types of commands received, such as
commands. However replies from the M2M CDMA Router are optional with
Enables or disables sending an acknowledgment message after execution of a
disabled, the router does not send any acknowledgement after execution of a
acknowledgment replies are stored in the Outbox after they have been sent.
This can be useful to determine if a command was received and executed by the router. This option is disabled by default.
Send Ack. SMS to
This option allows you to specify where to send acknowledgment messages after the execution of a
If a fixed number is selected, the acknowledgement message will be sent to the number defined in the Fixed number to send replies
to field. If the sender's number is selected, the acknowledgement message will be sent to the number that the SMS diagnostic or
command message originated from. The default setting is to use the sender's number.
Send Error SMS for Get/Set/Exec Command
Enables or disables the sending of an error message resulting from the execution of a
are stored in the Outbox after they have been sent.
Send Error SMS to
When Send Error SMS for Get/Set/Exec Command is set to ON, this option is used to specify where the error SMS is sent. Use the
radio buttons to select either Fixed Number or SMS Sender Number. When set to SMS Sender Number the router will reply to the
originating number of the SMS diagnostic or command. When set to Fixed Number the router will send the error messages to the
number specified in the following field.
Fixed Error SMS Number
This field defines the destination number to which error messages are sent after the execution of a
field is only displayed when Send Error SMS to is set to Fixed Number.
Max. Diag SMS Tx Limit
You can set the maximum number of acknowledgement and error messages sent when an SMS diagnostic or command is
executed. The maximum limit can be set per hour, day, week or month. The router will send a maximum of 100 replies by default.
The number of messages sent is shown below the options. The total transmitted message count resets after a reboot or at the
beginning of the time frame specified.
www.netcommwireless.com
get
commands, or
set
Wakeup
commands and the
set
command or SMS Wakeup command. If
set
command or SMS Wakeup command. All
set,
get
,
set
, or
exec
command. All error replies
get
set,
,
M2M CDMA Router – SMS Tools User Guide
execute
command. This option
or
exec
command.
exec
or
command. This
9
Advertisement
