Components List; Additional Components Required; Placement Clearance Requirements - kozy heat Minneapolis MPS-30 Installation And Operation Manual

#MPS-30 COMPONENTS
PART NUMBER
MPS-600-IPI
700-203
MPS-135
RFD-B-900
JXL-028
101-BLK
JOR-057T
OCK-A53L-I-MPS-PSE
816-CL1
700-208
700-GLT

ADDITIONAL COMPONENTS REQUIRED

Vent System; Part #816-CL: For use with minimum 6" x 8" I.D. masonry or 7" I.D. Class A metal chimneys - Includes 12 ft. (3.66 m)
Other approved venting: ICC, Selkirk, American Metals, Simpson Dura-Vent, RLH, Security, Metal Fab
Shrouds: Standard shrouds are available for this insert and will fit most applications. Custom shrouds may be ordered on a non-returnable
basis. When ordering a custom shroud, please specify the existing fireplace front opening height and width.
Blank Shrouds: Blank shrouds are available for on-site custom fit applications and are sized to the opening after the insert has been
installed. The interior perimeter is properly sized to fit onto the insert. The outer perimeter must be cut, formed and
finished (painted).
Screen Fronts: Screen fronts in various finishes.

PLACEMENT CLEARANCE REQUIREMENTS

This fireplace must be installed on a level surface capable of supporting the fireplace and venting.
This fireplace insert is to be installed into a solid fuel masonry or factory built non-combustible fireplace that has been installed in
accordance with the National, Provincial, State and local building codes.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the large amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
DESCRIPTION
Control Board Assembly
Manual Gas Shut-off Valve
Burner Assembly
Firebox Liner Set
Fan Kit
Black Glass Media Kit
Glass Frame Assembly
LP Conversion Kit
Co-Linear Air Duct
Remote Control
Glass Latch Tool
compressed, expandable to 35 ft (10.67 m) co-linear 3" x 3" flexible chimney, and termination cap.
Approved caps listed on page 14.
To be used with;
or
PAGE 8