Tools; Site Survey; Ping Reboot - Teltonika RUT100 HSDPA User Manual

4.9 Tools

4.9.1

Site Survey

The Site Survey test shows overview information for wireless networks in a local geographic
area. Using this test, an administrator can scan for working access points, check their operating
channels, encryption and see signal/noise levels. An administrator can use this feature to identify a clear
channel to set the device.
Note: Note that Site Survey function can take several minutes to perform.
A Site Survey test is performed every time on the startup of the device, therefore the results of
the last performed Site Survey test and its time can be found on the page. Thus, to obtain the results,
the initiation of the scan is not necessary. To perform the Site Survey test currently, click the Scan
button:
Figure 47. Site Survey Table
Note: The Site Survey function is impossible if the selected wireless interface is disabled.
4.9.2

Ping Reboot

The Ping Reboot feature allows rebooting the router if the connection to GSM network is lost.
This feature checks (using ICMP echo request, like ping utility) if specific hosts are accessible on the
network. Function allows adding several host IP addresses. When at least one server does not respond
the router is rebooted if the check box "Enable reboot if no echo received".
Figure 48. Site Survey Table
Enable – check the box to enable Ping Reboot feature.
Ping interval – specify the monitoring time period in seconds
Retry count – specify the number of failed reach ability checks
Enable reboot if no echo received– enable reboot the router if no echo to sent ICMP
requests is received.
IP address – Set the host IP address to which ICMP requests will be sent.
Add – Click to add host IP.
40 | P a g e