Getting Started; Initial Setup; Router Installation Guide - Teltonika RUT100 HSDPA User Manual

3 GETTING STARTED

3.1 Initial setup

3G Mobile Router enables to access network using a wireless connection from virtually
anywhere within the operating range of wireless network. Some things should be considered before
finding place to set up access point:
1. Make sure the power outlet is nearby as the router requires power supply.
2. Keep the access point as central in work area as possible.
3. The number of walls and ceilings between the router and other network devices should be kept
to a minimum as each wall or ceiling probably will reduce adapter's range from 1-30 meters.
Signal strength and speed fall off with distance.
4. Higher is often better. Set up the router on the top shelf of a bookcase rather than the bottom
one, if it is possible. The antenna usually works best if oriented to point straight up.
5. Building materials make a difference. A solid metal door or aluminum studs may have a
negative effect on range. Try to position access point and computers so that the signal passes
through drywall or open doorways. Materials and objects such as glass, steel, metal, walls with
insulation, mirrors, file cabinets, bricks, and concrete will degrade wireless signal.
6. Keep router away (at least 1-2 meters) from electrical devices or appliances that generate RF
noise.
7. If you are using 2.4GHz cordless phones or other wireless products your wireless connection
may degrade dramatically or drop completely. Make sure your 2.4GHz phone base is as far
away from your wireless devices as possible. The base transmits a signal even if the phone in
not in use.

3.2 Router installation guide

1. Attach Wireless LAN and GSM antennas.
Remove the antenna from its plastic wrapper.
Screw the antenna in a clockwise direction to the back panel of the unit.
Position the antenna upward at its connecting joint. This will ensure optimal reception.
2. Insert the SIM card which was given by your GSM (mobile) service provider.
3. Insert the Ethernet cable into LAN Port if the router will be configured using wired
connection.
4. Connect the power adapter to the socket on the front panel of 3G Mobile Router. Then plug
the other end of the power adapter into a wall outlet or power strip.
Note: SIM card is mandatory for setting up connection to the GSM network. However, the
manufacturer of this equipment does not supply the SIM card. The SIM card can be purchased from
your GSM (mobile) service provider! For APN, user name and password please contact your GSM
(mobile) service provider. The 3G Mobile Router must be powered off while inserting or taking out the
SIM card.
9 | P a g e