Tools; Site Survey; Ping Reboot - Teltonika RUT104 User Manual

Enable - Click to enable or disable the DMZ.
Destination IP address - Type a host IP address for the DMZ. All remaining incoming
packets will be sent to this IP address.
4.10

Tools

4.10.1 Site Survey

The Site Survey test shows overview information for wireless networks in a local geographic
area. Using this test, an administrator can scan for working access points, check their operating
channels, encryption and see signal/noise levels. An administrator can use this feature to identify a clear
channel to set the device.
Note: Note that Site Survey function can take several minutes to perform.
A Site Survey test is performed every time on the startup of the device, therefore the results of
the last performed Site Survey test and its time can be found on the page. Thus, to obtain the results,
the initiation of the scan is not necessary. To perform the Site Survey test currently, click the Scan
button:
Note: The Site Survey function is impossible if the selected wireless interface is disabled.

4.10.2 Ping Reboot

The Ping Reboot feature allows rebooting the router if the connection to GSM network is lost.
This feature checks (using ICMP echo request, like ping utility) if specific hosts are accessible on the
network. Function allows adding several host IP addresses. When at least one server does not respond
the router is rebooted if the check box "Enable reboot if no echo received".
Enable – check the box to enable Ping Reboot feature.
Figure 30. DMZ settings
Figure 31. Site Survey Table
Figure 32. Site Survey Table
31 | P a g e