Section 3: Propeller And Spinner Installation - Hangar 9 Assembly Manual

Section 3: Propeller and Spinner Installation

Required Parts
• Fuselage assembly
• Propeller
Required Tools and Adhesives
• Adjustable wrench

Step 1
Remove the plastic shipping saver, nut and washer from
the engine crankshaft.

Step 2
Check that the flywheel is fully installed on the engine. It
will fit closely to the engine when it is positioned correctly.
Slide the spinner backplate onto the engine crankshaft so
it is tight against the flywheel.
• Spinner assembly
• Hex wrench: 2.5mm

Step 3
Slide the propeller onto the engine crankshaft. The
blades of the propeller will be positioned against the
bosses for the spinner screws of the spinner backplate
as shown below.

Step 4
Slide the propeller washer onto the engine crankshaft.
13