Section 5B: Optional: Gluing The Wing Halves - Hangar 9 Assembly Manual


Step 5
Connect the clevises from the aileron pushrods to the
aileron control horns. The alignment of the ailerons will be
checked later in this manual.

Section 5b: Optional: Gluing the Wing Halves

Required Parts
• Wing panel (left and right) • Wing tube
• Covering (white)
Required Tools and Adhesives
• 30-minute epoxy
• Mixing stick
• Rubbing alcohol
• Painter's tape
Note: It is not necessary to glue the wing
panels together on your model. This section
has been provided in case you opt to do
so. Make sure your vehicle has enough
room to transport the joined wing before
joining the wing panels using this method.
• Covering (orange)
• Mixing cup
• Epoxy brush
• Paper towel
• Covering iron
Section 5: Wing Assembly

Step 1
Slide the wing tube into the wing panel as shown. The
wing tube will only slide in halfway, so do not force it in
any further than it will slide easily.
17