Removing The Cfr Front Panel And Cover - Alpha Technologies CFR 600 Operator's Manual

6. MAINTENANCE

6.4 Removing the CFR Front Panel and Cover

CAUTION: INTERNAL MAINTENANCE SHOULD BE SERVICED ONLY BY
QUALIFIED PERSONNEL.
1. Disconnect all loads from the OUTPUT receptacles on the UPS.
2. Switch the rear panel BATTERY circuit breaker OFF.
3. Disconnect the UPS from the AC wall receptacle.
4. If an external battery pack is connected to the UPS, remove the connector
from the UPS rear panel.
5. Loosen the two (2) Phillips screws from the UPS front panel (located in the
lower grill). Carefully pull the lower part of the front panel away from the UPS
and lift the panel straight up.
6. Remove the eight (8) Phillips screws from the sides of the UPS.
7. Carefully lift the cover upward until it clears the chassis.
Cover Screws
(on rear panel)
Front Sub-Panel Screws
Figure 16
Front Panel Removal
50
Requires
Phillips Screwdriver
Cover Screw
(behind front panel)