Jet JWL-1442VS Operating Instructions And Parts Manual page 4

Diameter of Work
Under 2"
2 to 4"
4 to 6"
6 to 8"
8 to 10"
10 to 12"
12 to 14"
26. When sanding, remove the tool rest from the machine, apply light pressure and use a slow speed
to avoid heat build up.
27. When turning large diameter pieces, such as bowls, always operate the lathe at low speeds. See
the speed recommendation chart.
28. Do not attempt to engage the spindle lock pin until the spindle has stopped. If leaving the
machine area, turn it off and wait until the spindle stops before departing.
29. Make no adjustments except speed changes with the spindle rotating and always disconnect the
machine from the power source when performing maintenance to avoid accidental starting or
electrical shock.
30. Provide for adequate space surrounding work area and non-glare, overhead lighting.
31. When stopping the lathe, never grab the part or faceplate to slow it down. Let the work coast to a
stop.
32. Use only JET factory authorized replacement parts and accessories; otherwise, the warranty and
guarantee are null and void.
33. Do not use this JET wood lathe for other than its intended purpose. If used for other purposes,
JET disclaims any real or implied warranty and holds itself harmless from any injury that may
result from that use.
Warnings
SPEED RECOMMENDATIONS
Roughing RPM
1500
600
450
450
450
450
450
4
General Cutting RPM
3000
1500
1100
600
600
600
450
Finishing RPM
3000
2300
1500
1100
850
850
600