Jet JWL-1442VS Operating Instructions And Parts Manual page 11

G. Headstock Spindle Lock: (G, Fig. 5)
Push in pin to keep the spindle from turning.
CAUTION!
Never press the headstock spindle lock while
the spindle is turning!
H. Headstock On/Off Switch: (H, Fig.5)
Flip the switch up to turn "ON" the lathe. Flip
the switch down to turn the lathe "OFF".
I. Headstock On/Off Switch Key: Remove
key (I, Fig. 5) when in the "OFF" position.
The switch will not work until key is
reinstalled.
J. Headstock Speed Selector: (J, Fig. 5)
Place handle directly above the desired
RPM speed. Pull handle out and move to
the desired speed, see Figure 6.
CAUTION!
Only change speeds while the spindle is
turning!
K. Headstock Faceplate: (K, Fig. 7)
Used for turning bowls. There are a number
of screw holes for mounting the workpiece.
Thread the faceplate onto the spindle in a
clockwise direction,
setscrews. Remove
loosening two setscrews. Push in headstock
spindle lock and use the provided wrench on
faceplate flats.
L. Headstock Spur Center: (L, Fig. 7)
Used for turning between centers. Spindle
taper is MT-2. Remove spur center by
inserting drift rod through the opposite end
of the spindle and knocking spur center out.
M. Headstock Indexing Hole: (M, Fig. 7)
Thread indexing pin into the indexing hole
making sure that it locates in the spindle
hole. There are 12 holes in the spindle 30°
apart. Three holes in the headstock casting
accept the indexing pin. These holes are 20°
apart. The combination of holes will allow
you to mark your workpiece for evenly
spaced features. See chart on page 32.
CAUTION!
Never start the lathe with the index pin
engaged in the spindle!
and tighten two
the faceplate by
11