JRC JLR-7700MKII Instruction Manual page 57

JLR-7700 MK 2 GPS Navigator
(2) Entering the Waypoint Name
Next, enter the waypoint name.
Press the
right hand side of the NAME.
Then, a list of characters will be displayed at the lower left corner of the screen.
Move the highlighted position to the desired character with the
ENT key.
Pressing the ENT key upon completion of the character input will register the name and automatically
return the screen to the original mode. Note that the input of a given waypoint name with less than eight
characters can be completed by pressing the INC or DEC and ENT keys.
Memo
Press the CLR key and
has been entered. Then, repeat the operations stated above to register a correct name.
The first character of the waypoint name will be displayed on the PLOT screen as the symbol for the
waypoint. Therefore, it is recommended to select an appropriate symbol or character at the beginning of
a given waypoint when naming it.
MINATO
This symbol is displayed on the PLOT screen.
(3) Entering the position
The position needs to be entered either with latitude and longitude, or bearing and distance.
Entering the latitude and longitude
The equipment accepts direct inputs of the latitude and longitude for the waypoint.
Example) To register the latitude 35 degrees 41.935 minutes north and longitude 139 degrees 14.562
minutes east as the waypoint.
Press the
9 , 3 , 5 , N/S
Then, press the 1 , 3 , 9 , 1 , 4 , 5 , 6 , 2 , E/W
longitude.
Pressing the ENT key after entering the longitude will execute the latitude and longitude inputs.
It is not necessary to press either the N/S
56
key provided on the
List of characters
Highlighted character
key provided on the right hand side of the NAME if a wrong character
key provided on the right hand side of the WPT L/L, then the 3 , 5 , 4 , 1 ,
, and ENT keys to register the latitude.
or E/W key if the display is correct.
key, then, press the
, and ENT keys to register the