Setting A Destination - JRC JLR-7700MKII Instruction Manual

The following operations can be made on the NAVIGATE screen.
4.3.1.1

Setting a Destination

Operate as follows in case it is necessary to set a route, from the current vessel position to a destination
(#003), if no route plan has been set according to the description stated under the item 4.5.3.1 "Setting the
Route Plan".
Press the GOTO , 0 , 0 , 3 , and ENT keys.
This operation will set the route from the current position to a destination #003.
"000 - 003" displayed in the RTE column on the upper left corner of the screen (NAVIGATE) represents the
route thus set.
Vessel position when the route was set
(Origin)
Note that setting a destination stated above can be set even when the route plan has already been set.
The setting method is shown below.
Resumption of a route
Let's assume a case when it is necessary to navigate the vessel to another destination by skipping a
planned destination if the vessel is found deviated from the route.
In this case, enter the new destination by making the GOTO operations. The navigation can be resumed
according to the preset route if any one of the waypoints included in the preset route plan is entered as the
new destination. However, it is not possible to resume the navigation according to the original route if a new
destination is not included in the preset route plan has been set.
Caution
The preset route plan will be canceled if a new destination is entered.
#000
* Note that the vessel position #000 does not represents a current
position, but starting point (origin) when the route was set.
JLR-7700 MK
Destination (#003)
Route
2 GPS Navigator
43