Installation Procedure Of The Dgps Receiver - JRC JLR-7700MKII Instruction Manual

3.1.2

Installation Procedure of the DGPS Receiver

The aluminum bottom of the DGPS Receiver is designed so that it can be installed on screws, mounting
conforming to 1" 14. The bottom of the receiver is provided with a slot to allow the receiver cable to be pulled
out to the side.
Pull out the receiver cable from aluminum base.
Screw screws, mounting into the aluminum base. As shown below grip the base. Don't grip joint between
cover and aluminum base.
Cover
Joint
Aluminum base
When the receiver cable is pulled out through the slot,
securer it in position to protect it against damage due to
vibration.
Connect extension cable with the DGPS receiver. Those
connectors should be sealed with selfbonding tape due to
water proofing.
Don't grip joint
Installation of the DGPS receiver
JLR-7700 MK 2 GPS Navigator
Grip the aluminum base
Tie wrap
Appearance
23