Installation Set-Up; Access To Controls; Opening The Top Cover; Removing The Top Cover - Barco R9000972 Installation Manual

4

INSTALLATION SET-UP

Installation only by BARCO authorized service personeel

Access to Controls

Opening the top cover

During the projector set-up and installation it is nec-
essary to open the top cover. Follow the procedure
as described below :
⊇ Turn the locking screw with a screwdriver or coin
counter clockwise;
⊄ Lift up and pivot the top cover.
WARNING :
The projector's top cover is not supported with
locking hinge. Open with care and support the cover
with your hand.

Removing the top cover

During some installations, it will be convenient to remove the top cover
from the projector totally.
Proceed as follows :
⊇ Loosen the lock screws by turning a quarter counter clockwise
with a screwdriver or coin and pull out the two hinge-joints.
⊄ Left up the top cover to remove.

Re-installing the top cover

To re-install the top cover on the projector :
⊇ Place the top cover on the projector until both hinges parts join
togheter.
⊄ Insert both hinge-joints.
⊂ Secure the locking screws by turning them clockwise with a
screwdriver or coin.
5975638 BARCOGRAPHICS 1209s 010797
All manuals and user guides at all-guides.com
WARNING :
Risk of electric shock !
Lock screws
Installation set-up
4-1