Novation ReMOTE SL COMPACT User Manual page 43

6. In Pro Tools, load a project then select 'MIDI -> Input Devices...' from the 'Setup' menu and ensure 'ReMOTE SL
Compact Port 3' is unchecked, then click 'OK'. This prevents Automap Universal data, intended for the Automap Server,
from being routed into Pro Tools.
The Pro Tools Automap template (template 34) must be selected on the SL Compact to use it in Pro Tools Automap mode.
Once you have followed the above set up instructions the SL Compact will automatically switch to the Pro Tools Automap
template and will do so each time you subsequently start Pro Tools. Whilst using the SL Compact in Pro Tools Automap
mode, you can switch to any other template on the unit (for example to control a soft-synth) and then switch back to the
Pro Tools Automap template to control Pro Tools again.
The Automap Universal server software allows tempo control from the SL Compact over any ReWire host application,
including Pro Tools, and also transport control from the Automap Universal template (see sections 7.2 and 13.1). For
this tempo and transport control to work you must enable the Automap Server as a ReWire input in Pro Tools. To do this
create a stereo aux track in your session and add an 'Automap Universal Transport' ReWire instrument plug-in to the first
insert slot on that track.
You can use the SL Compact to control the Pro Tools mixer as follows:
The encoders can control track levels, panning, as well as send levels and panning (in FLIP Mode, see below). The
ENCODERS GROUP SELECT SWITCHES determine what the encoders control. encoders Group A controls panning of the
Left channel for a stereo track, whilst encoders Group B controls panning of the right channel. encoders Group A should
be used for the panning of a mono track. encoders Group C controls track levels. When controlling track level or send
level from the ReMOTE SL Compact, press and hold the ENCODERS C GROUP SELECT SWITCH whilst rotating an encoder
to see the slider level in dB on the ReMOTE SL Compact display.