Controlling A Sequencer Mixer With Automap Universal - Novation ReMOTE SL COMPACT User Manual

8 CONTROLLING A SeQUeNCeR MIXeR WITH
AUTOMAP UNIVeRSAL
At the time of writing only the following sequencers support Automap Universal Mixer Control:
Cakewalk Sonar (version 6.2 or later, including version 7)
Mackie Tracktion (version 3.0.4.6 or later)
Steinberg Cubase (version SX/SL/SE 3.1.1.944 or later, including versions 4, Studio 4 and LE 4)
Steinberg Nuendo (version 3.2.1.1153 or later, including version 4)
Support for other sequencers will be included in future updates so keep an eye out on www.novationmusic.com for
update news.
You will need to follow the relevant set up instructions for your sequencer, given in sections 8.1 to 8.3. After you have done
so a control map for your sequencer mixer will appear in the Mixer group of control maps. This control map will appear
each time you subsequently start your sequencer and disappear when you quit it. Only one control map can be used to
control a sequencer mixer – you cannot create more control maps for the same sequencer mixer. Remember however
that, as with any other control map, you can create as many pages in the mixer control map as you like.
The default parameter mapping for the mixer control map is as follows:
When using the SL Compact to control a sequencer mixer you can clear and assign parameters just as you would when
controlling a plug-in, as described in section 7.7. Only the following mixer parameters can be assigned:
Track level
Track pan
Mute
Solo
Record Arm
Send level
After clearing and learning parameters, you can use the 'Set As Default' option to save the current control map as the
default mixer control map that loads when you open or start a new a sequencer project. With the exception of Tracktion,
any changes to the default mixer control map are not automatically saved with the project. If you change the default
mixer control map to suit the needs of a particular project then you must save the control map using the 'Save As...'
option before closing the project. After reopening the project, select the mixer control map from the Browser View of the
Automap Universal window and then use the 'Open...' option to load the previously saved mixer control map.