The Accessory Case
built into your Elne-tx is a true fitted case, where
every accessory has its place. There is no longer any
separate box to be mislaid. it is an integral part of
9 Should you have to change the needle
Hold the needle with its flat part against the index
1-2Raise the clasp slightly and open the cover. In the
finger and push it as far as it will go into the
1case you wils
idhtly acessoriesnd eov
needle clamp. Tighten the screw firmly (no need
case you will find the accessories and removable
for a screwdriver). Use needles of the system
130/ 705H (15 1).
(3 sewing foot already in place on the machine)
10 Should you have to change the sole of the foot
4 embroidery foot
a) Raise the foot. By pressing downwards on the
sole of the foot with the fingers, it is
5 zipper foot
disengaged and can be removed easily.
blind stitch foot
b) Place the other sole under the foot support
attachment. Lower the foot and press on the
buttonhole foot with slide
support with the fingers so that the sole
darning foot and plate
engages by itself.
2 bobbins (plus one already placed in the rotary
11 If you use a foot that is attached in the
conventional manner, the support fixing screw can
Assortment of needles and a needle threader
be unscrewed, Remove the support and attach the
Small cleaning brush and oiler
foot in its place. Tighten the fixing screw firmly.
Buttonhole knife and seam ripper
For the darning foot see pages 34/35.