Download  Print this page

Threading The Upper Thread - ELNA TX Instruction Manual

Hide thumbs

Advertisement

Table of Contents
Threading the Upper Thread
Make sure that the thread take-up lever and the foot
4 Thread take-up lever - pass the thread through
are in their highest positions,
the rear of the notch in the cover, from right to left,
passing it around the thread take-up lever. The
1 Pull out the spool pin and place the spool of
thread will slip into the opening of the thread take-
thread on it. Hold back the spool with the tip of
up lever.
your finger and pass the thread through in the
following order: (all the thread guides are open,
5 Thread guide.
including the thread take-up lever).
6 Needle clamp. Pull the thread well Into the clamp.
2 Thread guide.
(Ba) The thread has not been pulled well into the
3 Universal upper thread tension, marked between
needle clamp.
4/2 and 5 .
(6b) Correctly threaded needled clamp.
7 Needle. It is threaded from the front to the back. (If
tto ensure good sewing
the needle threader is used, it must therefore be
Important
tinserted
Into the eye of the needle from the back).
results:
8 Pull forward about 15 cm (6") of thread to the
Give the thread a sharp tug upwards so that it is
front.
properly engaged in the tension device (3).
Check: If the thread is then pulled downwards,
e ln a
it should not come out of the tension device.
1

Advertisement

Table of Contents

This manual is also suitable for:

Tx electronic 57

Comments to this Manuals

Symbols: 0
Latest comments:
  • Jeme Prinss Nov 06, 2018 01:41:
    هل يشتغل مكينه بدون دعاسه الرجل