If you are using your Elna-tx
for the first time or have not used it for some time,
5 Place the bobbin on the bobbin winder, holed side
put a drop of oil in the rotary hook, on the point
marked in red.
6 Pull out the spool pin and place the spool of
thread on it.
Wind the bobbin
7 Pass the thread through the raised thread guide.
8 Wind the end of the thread around the bobbin by
For the usual sewing jobs, it is best to use a medium-
hand, in the direction indicated and push the
bobbin winder to the right.
2 Raise the thread guide which is under the cover of
9 Wind the bobbin, pressing lightly with a finger on
the accessory case and which serves for bobbin
the spool so as to stretch the thread better and
winding and for threading the upper thread (see
thus fill the bobbin to a maximum. The full bobbin
also page 16). Close the cover,
3 Disengage the flywheel by unscrewing the
10 Re-engage the flywheel by tightening the coupling
coupling knob as far as it will go.
knob in the opposite direction to the arrow. Cut
4 Slide the knob of the electronic speed control to
the thread and remove the bobbin from the winder
the position "X ", bobbin winding.
by pushing the latter to the left,