Your ElIna-tx is a convertible
sewing machine
You can use it with the convenient sewing table, by
To reclos. the flaps: Turn the flywheel by hand to
leaving the protection flaps opened out, or with the
move the thread take-up lever to its lowest
free arm.
position.
You can obtain a practical free arm by removing the
3 protection flaps, namely:
1-2 Flaps 1 and 2: open (or raise) the flaps to a
You then put the flaps back In place In the reverse
horizontal position (a), press them towards the red
order.
mark (I) and lift the other end (11). The flaps will
then come free.
3 Start by inserting flap 3 In the slit.
3 Flap 3: press the button (b) while raising and
The red mark 0* should be on the outside.
pulling the flap upwards.
Push it right down, until It clicks Into place.
4 You thus have a free arm. It makes it easy to sew
2-1 Next, fit the flaps 2 and 1, holding them in a
the openings of trousers, the waistbands of skirts,
horizontal position. Place the end marked In reda
aprons, patches on the seats of trousers, pockets,
(I) in the hole of the hinge. Press the flap towards
d
n a
etc.
the hinge and insert the other end (11) in the hole,
5
Need help?
Do you have a question about the TX and is the answer not in the manual?