Power Computing Minitower 132 User Manual page 9

N N N N o o o o t t t t e e e e : : : :
All DIMMs must be 168-pin, fast-paged mode, 70-nanosecond RAM access time or faster. The
PowerCenter has four DIMM slots near the front on the motherboard. DIMMs may be installed in
any slot.
Removing RAM
1. Remove the chassis cover (
2. Place the unit on its side with the MLB on the bottom and the open side facing up.
3. Locate the DIMM(s) you would like to remove (
module by reaching in and pushing down on the small lever at the end of the DIMM slot. (
Figure 4: Removing RAM on page 9).
Figure 3:
DIMM slot
location
4. Grasp the DIMM module on each end and evenly pull the module up and out of the slot.
Installing RAM
1. Hold the module (with the contacts down) with one hand at each end. Notice that there are two
notches in the contact edge of the DIMM module.
2. Lower the DIMM squarely into the slot so that the notches in the DIMM line up with the notches
CONFIDENTIAL
RAM Removal/Installation
RAM Removal/Installation
refer to Chassis Cover Removal/Installation on page 6).
see Figure 3: on page 9).
The DIMM should pop loose from the slot at the lever end.
DIMM Slots
Loosen the desired DIMM
see
Figure 4: Removing RAM
9