Table of Contents
Advertisement
Removing the 3.5-inch Drive
1. Remove the chassis cover (
2. Remove all cables from the drive.
3. Remove the four retaining screws securing the drive to the mounting bracket.
4. Lower the drive out of the bracket straight down and out of the bracket.
Figure 11:
Removing a
3.5-inch
Installing the 3.5-inch Drive
1. Place the drive in the mounting bracket.
2. Secure the drive to the bracket with four retaining screws.
3. Attach all necessary cables tothe drive.
4. Remove the chassis cover (
5. Reset the CUDA (
6. Install the chassis cover (
21
3.5-inch Drive Removal/Installation
3.5-inch Drive Removal/Installation
refer to Chassis Cover Removal/Installation on page 6).
refer to Chassis Cover Removal/Installation on page 6).
refer to CUDA Reset on page 4).
refer to Chassis Cover Removal/Installation on page 6).
3.5-inch internal
drive bay
CONFIDENTIAL
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Minitower 132 and is the answer not in the manual?
Questions and answers