Power Computing Minitower 132 User Manual page 10

in the slot. Slide the contacts straight into the slot and make sure the contacts are firmly seated.
(
see Figure 5: Installing RAM on page 10).
should not be visible.
N N N N o o o o t t t t e e e e : : : :
DonÕt force the DIMM module into the slot; if the MLB starts bending significantly, pull the
DIMM out, reposition it, and try again. If the DIMM module is seated correctly, the lever at the
end of the DIMM slot should be completely raised.
3. Reset the CUDA (
refer to CUDA Reset on page 4).
4. Replace the chassis cover (
CONFIDENTIAL
When properly seated, the contacts on the bottom
Figure 5: Installing RAM
refer to Chassis Cover Removal/Installation on page 6).
10