Power Computing Minitower 132 User Manual page 14

2. Lower the CPU card squarely into the slot so that the notch in the CPU card lines up with the
notch in the slot. Slide the contacts straight into the slot and make sure the contacts are firmly
seated. (
see Figure 9: CPU removal on page 13).
should not be visible.
N N N N o o o o t t t t e e e e : : : :
DonÕt force the CPU card into the slot; if the MLB starts bending significantly, pull the CPU card
out, reposition it, and try again.
3. Replace the CPU fan assembly by lining up the tab and sliding the entire assembly toward the
rear of the chassis.
4. Reconnect the CPU fan to the main logic board. Route the cable so it does not contact the chips
on the RAM DIMMs.
5. Reset the CUDA (
6. Replace the chassis cover (
14
refer to CUDA Reset on page 4).
refer to Chassis Cover Removal/Installation on page 6).
When properly seated, the contacts on the bottom
CONFIDENTIAL