Power Computing Minitower 132 User Manual page 27

Figure 16: Main logic
board removal
Installing the MLB
1. Lower the MLB into the chassis at an angle. Lay the board flat and align the mounting holes with the
posts.
2. Replace the eight screws that secure the MLB to the chassis.
3. Reconnect the cables attached to the MLB. Connect the power cable by pressing the retaining
clip facing the front of the computer, then pressing down. Connect all remaining cables to their
connectors.
N N N N o o o o t t t t e e e e : : : :
If the cable does not have a directional connector, then connect it with the label on the cable
connector facing the rear of the computer.
4. Install the RAM (
refer to RAM Removal/Installation on page 9).
5. Install the VRAM (
refer to VRAM Removal/Installation on page 11).
6. Install the Cache card (
7. Install the CPU (
refer to Installing the CPU on page 13).
8. Install the PCI Riser card and assembly (
9. Install the PCI card(s) (
10. Replace the base. The base is retained with two screws on the back in the bottom center of the
computer and one directly on the bottom of the computer. Slide the base toward the front of the
CONFIDENTIAL
refer to Installing the Cache on page 15).
refer to PCI Riser Card Removal/Installation on page 19).
refer to PCI Cards Removal/Installation on page 16).
Retaining screws
27