Removing The Floppy Disk Drive; Installing The Floppy Disk Drive - Power Computing Minitower 132 User Manual

Removing the Floppy Disk Drive

1. Remove the chassis cover (
2. Disconnect the cable connected to the floppy disk drive.
3. Remove the two screws that secure the floppy disk drive cage to the 5.25-inch drive cage above it
and the front of the chassis.
4. Slide the floppy disk drive cage toward the rear of the computer to unhook it from the 5.25-inch
drive cage. Pull the floppy disk drive cage straight out the side of the computer
5. Remove the four screws that secure the floppy disk device to the mounting cage.
6. Slide the drive out of the mounting cage.
Figure 14:
Removing the floppy
drive bayy

Installing the Floppy Disk Drive

1. Slide the drive into the drive cage and line up the drive with the holes on the drive cage.
2. Replace the four screws that secure the drive to the drive cage.
3. Align the tabs on the drive cage with the slots on the bottom of the 5.25-inch drive cage. Slide
the floppy disk drive cage forward to hook it in place.
24
Floppy Disk Drive Removal/Installation
Floppy Disk Drive Removal/Installation
refer to Chassis Cover Removal/Installation on page 6).
Floppy drive
CONFIDENTIAL