Power Computing Minitower 132 User Manual page 17

Figure 10: Removing PCI
slot cover
Slot cover screw
4. Hold the PCI card (contacts facing down) with one hand at each end. Notice that there is a notch
in the contact edge of the PCI card.
5. Lower the PCI card squarely into the PCI riser card so that the notch in the PCI card lines up with
the notch in the PCI riser card. Slide the contacts straight into the PCI riser card and make sure
the contacts are firmly seated. (
seated, the contacts on the bottom should not be visible. Secure the PCI card to the chassis with
the retaining screw.
Figure 11: PCI card
installation
Slot cover screw
N N N N o o o o t t t t e e e e : : : :
DonÕt force the PCI card into the slot; if the PCI riser card starts bending significantly, pull the
PCI card out, reposition it, and try again.
17
PCI slot cover
see Figure 11: PCI card installation on page 17).
PCI slot
When properly
PCI card
CONFIDENTIAL