Power Computing Minitower 132 User Manual page 20

Installing the PCI Riser Card
1. Lower the PCI riser card squarely into the PCI slot so that the notch in the PCI card lines up with the
notch in the PCI slot. Slide the contacts straight into the PCI slot and make sure the contacts are firmly
seated. When properly seated, the contacts on the bottom should not be visible.
2. Replace the support cross beam and its retaining screws.
3. Reconnect the power cable of the CPU cooling fan. Route the cable so it does not contact the
chips on the RAM DIMMs.
4. Replace the screws that attach the PCI riser card to the support beam.
5. Reset the CUDA (
6. Install the chassis cover (
20
refer to CUDA Reset on page 4).
refer to Chassis Cover Removal/Installation on page 6).
CONFIDENTIAL