Installing Power Supply - Power Computing Minitower 132 User Manual

Installing Power Supply

1. Slide the power supply into place, making sure that it is seated properly.
2. Secure the power supply with the four retaining screws on the back of the chassis.
¥ the first screw is located above and to the left on the chassis
¥ the second screw is located below and to the left on the chassis
¥ the third screw is located above and to the right on the chassis
¥ the fourth screw is located below and right on the chassis
3. Connect the power connectors to all internal SCSI devices.
4. Connect the logic board power connector to the MLB.
5. Reset the CUDA. (
refer to CUDA Reset on page 4).
6. Install the chassis cover (
refer to Chassis Cover Removal/Installation on page 6).
30
CONFIDENTIAL