Filter Display Indicator Activation - Follett 7UC100A Installation, Operation And Service Manual

Filter Display Indicator Activation –––––––––––––––––––––––––––––––––––––
If you purchased your dispenser with a Follett fi lter, the fi lter display indicator
activation has been preset at the factory.
If you are using an "after market fi lter," an adjustment may be made to
activate the "Fresh Filtered Ice & Water" display.
Activating "Fresh Filtered Ice & Water"
1. Remove the front panel as explained in
Components on page 8
2. Remove top panel (Fig. 7.1).
3. Remove (1) screw and top of control board enclosure (Fig. 7.2).
4. Locate the DIP switches on the dispenser's control board (Fig. 8).
Use a fi ne-pointed object to move the "Filter" DIP switch (DIP switch
#3) to the ON position.
Deactivating the Six-Month Maintenance/Filter Change Reminder
1. Use a fi ne-pointed object to move the "PM" DIP switch (DIP switch
#8) to the ON position.
OFF
Not used (OFF position)
Ice only
No internal filter
Not used (OFF position)
Not used (OFF position)
15 minute delay
Not used (OFF position)
Six-month PM enabled
Accessing Internal
then refer to Fig. 7.
ON
Ice & water
Internal filter supplied or to display "Fresh Filtered"
30 minute delay
Six-month PM disabled
Undercounter Dispenser and Icemaker 7UC100A/7UD100A
Fig. 7
1
2
Fig. 8
9