Table of Contents
Advertisement
ADJUSTING THE LEGRESTS
The angle is adjusted simply by lifting it by hand, automatically locking at the required angle, up to a
maximum of 113° .
To lower the leg support, push lever (A) up until you reach the required angle.
The height, depth and width of the calf plate cushions can be adjusted and they can be folded away
towards the inside of the wheelchair to facilitate the transfer of people.
• Adjusting the height
• Adjusting the depth
• Adjusting the width
then tighten.
• Folding away the calf plate towards the inside of the wheelchair
B
Adjusting the angle and depth of the footplates. (picture 8 and 9)
• Adjusting the angle
• Adjusting the depth
the desired depth (three possible positions) and tighten.
A
Loosen screw (A), move to the desired height, then tighten.
Loosen screw (B), move to the desired depth, then tighten.
Loosen the 2 screws located behind the calf plate, move to the desired width,
A
C
Pic. 8
A
Loosen the black screw (A), adjust to the correct angle and tighten.
Loosen the two screws (A) and (B) on the footplate of the footrest and adjust to
push button (C) up.
6
SERENYS
2012-03
Pic. 6
Pic.7
Pic. 9
A
B
Advertisement
Table of Contents
