Table of Contents
Advertisement
l
This position may only be used on horizontal surfaces (do not use it on slopes, inclinations or
unstable surfaces).
l
This position is not meant to be used as a permanent position.
l
Never use this position to move the wheelchair, with the user still inside the wheelchair.
ADJUSTING THE HEIGHT OF THE SEAT
1. Remove the two pins (A) (lower cylinder fastener) located on the right and left sides of the frame.
Move to desired height. There are three possible positions.
L
Very important close the pin's safety buckles
2. Unscrew the two screws (B) on each side of the frame at the front of the wheelchair (under the seat),
tighten the screws (B) after having determined the desired setting and moving it to the desired height;
there are also three possible positions.
L
These adjustments can also be used to place the seat and backrest at different angles.
A
We can offer you a variety of combinations with the rear wheels and the adjustments with the pneumatic
jacks. The pictures below will give you an oversight on the possible combinations.
B
C
A
1
X
2
3
A
D
1
2
3
B
C (22")
D (22")
X
X
X
X
X
X
X
8
Height of the seat (ground,
B
seat)
Front
Back
A and B = Use original 24" wheels
C and D = Use 22" wheels for a very
low adjustment. You cannot use this
setting in combination with the original
24" wheels.
X = possible
= Inpossible
SERENYS
2012-03
Pic. 11
520 to 450 mm
380 to 530 mm
Advertisement
Table of Contents
