Table of Contents
Advertisement
MOUNTING THE WHEELCHAIR
•
Frame (pic. 2)
After having removed the wheelchair from its original packaging, raise the backrest towards the rear up to
a position of around 90° and place pin (A) into its socket so as to attach cylinder (B) located under the
rear of the seat, placing the wires over the cylinder before closing the pin.
A
L
Please check that the pin's safety buckle is closed.
•
ARMRESTS (Pic. 3)
Put the right and left armrests in the appropriate sockets. The height can be adjusted using sliding part
(A). It can be adjusted using Allen screw (B) ∅ 4 mm, located on the rear.
B
L
Please ensure that the screw is securely tightened before mounting the armrest.
L
The right armrest can be adjusted differently from the left armrest.
•
Legrests (Pic. 4)
Place the leg support in its socket from above, and then move it down vertically until it is fixed. To fold
away the leg supports outwards, lift the leg support up slightly (around 25 mm) and swivel it outwards.
This process is required before transferring people.
Do the reverse process to lock the leg support.
B
A
4
SERENYS
2012-03
Pic. 2
Pic. 3
Advertisement
Table of Contents
