Toshiba E-Studio 655 Troubleshooting Manual page 37

1.TROUBLESHOOTING FOR THE HARDWARE
6
Remove the jammed staples.
Do not touch the stapling area (A in the figure).
The actual needle point could cause you personal injury.
7
Push the knob (2) to return it to its original position.
Make sure that the lever (1) is latched on the shutter.
8
Fit the staple cartridges.
Push down each cartridge until it is fixed with a click.
9
Unlock the stapler by pulling its handle toward you.
Then return the stapler to its original position.
10
Carefully insert the saddle stitch unit into the finisher.
11
Make sure of the following two requirements before test stapling:
The Saddle Stitch Finisher is securely attached to the equipment.
A3, B4, A4-R, LD, or LT-R paper is set in the drawer.
1 TROUBLESHOOTING FOR THE HARDWARE
A
2 1
2
Clearing a Staple Jam
1
35