Toshiba E-Studio 655 Troubleshooting Manual page 26

1 TROUBLESHOOTING FOR THE HARDWARE
10
When the finisher is installed, separate it from the
equipment.
Separate the finisher from the equipment while pressing the lock lever.
Place your hand on portion A in the figure and then move the finisher
carefully.
11
Open the exit cover.
12
Remove the jammed paper on the exit cover side.
Do not touch the metal portion of the reverse unit (A in the
figure) or the guide plate (B in the figure).
It could burn or injure you.
13
Remove the jammed paper from the middle of the
reverse unit.
14
Open the front cover of the equipment.
24 Clearing a Paper Jam
A
B A