Operation - Makita TM3000C Instruction Manual

1
2
3
4
012850
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).

OPERATION

WARNING:
Before starting the tool and during operation, keep
•
your hand and face away from the application tool.
Do not apply excessive load to the tool which may
•
cause a motor lock and stop the tool.
Cutting, sawing and scraping
012889
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 3 - 5.
Sanding
WARNING:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding paper
•
without grit.
1. Application tool
installation bolt
2. Holes in the
application tool
3. Adapter
4. Protrusions of
the tool flange
6
012853
Apply a sanding paper on the workpiece.
NOTE:
Using a test
•
recommendable to determine a correct orbital
stroke rate suitable for your work.
Use a sanding paper with the same grit until
•
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
Dust extraction attachment
(optional accessory)
4
5
6
7
1. Joint
2. Nozzle band
3. Dust nozzle
4. Dust attachment
5. Felt ring
6. Pad
7. Application tool installation bolt
012854
material sample to
3
1
2
try is