Table of Contents
Advertisement
Available languages
Available languages
OPERATION
CAUTION:
Keep the bolt tips off of the
ground, floor, walkways, etc. to prevent injury
from tripping or falling.
1.
Tighten bolts preliminarily by using a hand wrench.
2.
Hold the tool firmly and place the inner sleeve over
the bolt so that the inner sleeve completely covers the
bolt tip.
Fig.11
► 1 . Inner sleeve 2. Bolt tip
NOTICE:
Be careful when fitting the sleeve onto
the bolt tip. Striking the tip can damage it so that it
will no longer fit inside the sleeve properly.
3.
Push the tool lightly until the outer sleeve com-
pletely hold the nut. If the outer sleeve fails to hold the
nut, rotate the tool clockwise or counterclockwise while
pushing the tool lightly.
4.
Pull the switch trigger. Then the outer sleeve
rotates to tighten the nut.
Fig.12
► 1 . Outer sleeve 2. Nut
NOTICE:
Do not force the tool down excessively.
Apply the downward force to the degree needed
to stabilize the tool.
1
2
1
2
9 ENGLISH
5.
When the specified torque is attained, the bolt
tip will be sheared at its notched portion. The bolt tip
remains inside the inner sleeve.
Fig.13
► 1 . Notched portion 2. Bolt tip
6.
Release the switch trigger and withdraw the tool in
a straight line.
Fig.14
► 1 . Outer sleeve
7.
Pull the eject lever to eject the bolt tip from the
tool. Catch the sheared bolt tips to prevent them from
falling.
Fig.15
► 1 . Bolt tip
1
2
1
1
Advertisement
Table of Contents
