Functional Description - Makita TM3000C Instruction Manual

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off and
•
unplugged before
function on the tool. Failure to switch off and
unplug the tool may result in serious personal injury
from accidental start-up.
Switch action
012768
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, slide the slide switch toward the "I (ON)"
position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.
Adjusting the orbital stroke rate
012852
The orbital stroke rate is adjustable. To change the orbital
stroke rate, turn the dial between 1 and 5. The higher the
number is, the higher the orbital stroke rate is. Preset the
dial to the number suitable for your workpiece.
NOTE:
The dial cannot be turned directly from 1 to 5 or
•
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke rate
is kept constant even under load condition.
adjusting or checking
1. Slide switch
1
1. Dial
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
Do not install application tool upside down.
•
Installing application tool upside down may damage
the tool and cause serious personal injury.
Install attachment tool in the correct direction
•
according to your work. Application tool can be
installed at an angle of every 30 degree.
1
2
3
012888
1
012851
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction, mount
a sanding paper so that the holes in a sanding paper
match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
5
1. Application tool
installation bolt
2. Holes in the
application tool
3. Protrusions of
the tool flange
1. Application tool
2
installation bolt
2. Hex wrench
3. Tighten
3