Table of Contents
Advertisement
80. Using isopropyl alcohol on a shop towel, clean the
areas where the urethane tape will attach.
Clean with
isopropyl alcohol.
LOWER COLUMN
COVER
(inside)
81. Attach two pieces of urethane tape to the inside of
the lower column cover.
82. Open the hood. Using isopropyl alcohol on a shop
towel, clean the hood where the caution label will be
attached.
HOOD
(Clean with
isopropyl alcohol.)
CAUTION
LABEL
ADHESIVE
BACKING
(Remove.)
83. Remove the adhesive backing from the caution
label, and attach the caution label to the hood.
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
84. Make sure that all harness and cables are routed
properly and that all connectors are plugged in.
85. Reinstall all removed parts.
2 URETHANE
86. Reconnect the negative cable to the battery.
TAPES
87. Check the operation of the headlights and wipers.
88. Press and hold the radio power button for two
seconds to restore the radio and navigation (if
equipped) system functions.
89. Reset the clock on vehicles without navigation.
90. Proceed to REMOTE ENGINE STARTER
REGISTRATION and Check the operation of the
Remote Control Engine Starter.
REMOTE ENGINE STARTER REGISTRATION
NOTE: Make sure the HDS has been upgraded to the
latest version.
1.
Retrieve the PCM code from the Interactive Network
(iN).
Q090601AK
2.
Connect the HDS/MVCI tester to the OBD II data link
connector, then turn the ignition switch to ON (II)
position.
3.
Start the HDS, and click the car icon.
Q0N2011AG
AII 50024-50373 (1308)
CAR ICON
QC31909AC
21 of 25
Hide quick links:
Advertisement
Table of Contents
