F F F F F AUL
AULT CODES
AUL
AUL
T CODES
T CODES
T CODES
AUL
T CODES
The Program Control knob has two fault codes: C
and S. If the knob stops on one of these, the machine
detected a problem.
C – This indicates a problem that can probably be
taken care of without calling a service technician.
S – This usually indicates a mechanical problem and
a service call will be required.
Refer to page 15 for more detailed information.
INTERRUPTING OR CHANGING A
INTERRUPTING OR CHANGING A
INTERRUPTING OR CHANGING A
INTERRUPTING OR CHANGING A
INTERRUPTING OR CHANGING A
P R O G R A M
P R O G R A M
P R O G R A M
P R O G R A M
P R O G R A M
If you need to stop or interrupt a program after you
start the machine, turn the Program Control knob
to 10 (Drain). Any water in the machine will be
pumped out. Press the Door Open button to open
the door. (It won't open until the water is out.) To
restart the washer, close the door, add detergent (if
needed), and turn the controls to the desired settings.
W600 AND W620 FAULT CODES
57